This CNG dispenser is a two-line dispenser that independently meters the gas and gives you a display on both sides of the dispenser. The pump has four 4-20ma outputs that can send flow or temperature to a controller. The dispenser has a dry contact and a 120v hook switch for an “in use” signal and will send pulses to a card reader or a console. The Micro Motion Transmitters are located within the dispenser body and are factory set and calibrated before shipment. TGT assembles an AGA 1-93 approved Parker Paraflex CNG fill hose on all its dispensers. The breakaway is the Snap-tite Inline type with a unique vent breakaway attached to the fill hose breakaway. All 1999 and later CNG Dispensers have an ASME pressure relief valve inside the dispenser cabinet with a vent stack up through the retractor pole. The cabinet is constructed of 11 gauge cold roll steel with a powder coat finish than a high-quality mirror stainless steel trim is attached to the outside of the cabinet which will give you years of new appearing equipment.